![physprof 1 0 seriale physprof 1 0 seriale](https://img.yumpu.com/4822709/1/500x640/sansp-110pdf-csir-research-space.jpg)
in figure Name Description For details see section Page X5 Fieldbus interface CH0 Fieldbus Connector (X5-10-pin) 23 X6 Fieldbus interface CH1 Fieldbus Connector (X6-10-pin) 23 V30 Communication status LED 0 LEDs 27 (green / red) V31 Communication status LED 1 LEDs 27 (green / red) S1 Boot strap options Configuration Boot Strap Options - 10 Switch (S1) X9 ETM-Interface netx 51 ETM Connector (X9) 25 X7 UART0 interface Serial Connector (X7-10-pin) 24 SW30 4 pol. It is equipped with an netx 51 and features: Host interface, usable in different interface modes: 8/16/32 bit parallel dual-port memory, 16 bit TI multiplexed parallel dual-port memory, serial dual-port memory (SPI Slave), MII and PIO 2-port RJ45 Real-Time Ethernet interface DIP switch to configure boot mode and host interface mode Power supply and diagnostic via USB interface MMIO signals and I2C interface ETM interface for debugging System status and communication status LEDs Quad SPI flash for Fast Start-Up feature of PROFINET IO Device microsd Card slot 3 interfaces for additional Fieldbus and RS-232 modules HiTOP USB debugging interfaceĨ Descriptions and Drawings 8/ Printed Circuit Board Figure 2: NXHX51-ETM Printed Circuit Board No.
![physprof 1 0 seriale physprof 1 0 seriale](http://phi0.org/files/6614/1275/7949/IMG_5683_01.png)
![physprof 1 0 seriale physprof 1 0 seriale](http://www.praetersoftware.com/new/wp-content/uploads/2019/07/MainWindow-2.png)
#Physprof 1 0 seriale manual
Table 3: Additional Documentation Migration_netX50_to_netX5152_MG03EN.pdf netx Programming Reference Guide PRG xx EN.pdf User Manual NXPCA-PCI_Rev_2_EN.pdfĦ Descriptions and Drawings 6/60 2 Descriptions and Drawings 2.1 Description of the NXHX 51-ETM The NXHX 51-ETM is a development board for the netx 51 controller. Describes the coupling of the parallel dual-port memory with a PC. Describes all available registers of the netx 51. Migration Guide netx 50 to netx 51/52 Programming Reference Guide netx 51/52 User Manual NXPCA- PCI Describes the differences between the netx 50 and netx 51/52. If the numbers reference to a section outside the current section then a cross reference to that section and figure is indicated.ĥ Introduction 5/ Reference to Hardware Hardware Revision Part Number NXHX51-ETM Table 2: Reference to Hardware 1.2 Other Relevant Documentation Besides this device description, the following documents are also relevant for the user of the NXHX 51-ETM development board: Manual Contents Document Name NXHX 51-ETM Getting Describes typical use cases of the NXHX 51-ETM Getting Started GS XX EN.pdf Started Guide NXHX 51 ETM Development Board. refer to the figure used in that section. Notes are marked as follows: Important: Note: Positions in Figures The Positions. Table 1: List of Revisions Conventions in this Manual # means active low signal. Schematics updated for hardware revision 4. Section Devices for Host Interface revised (formerly section Host Interfaces) Description of the Host Mode Configuration Switch (S2) updated for hardware revision 4. Section Fieldbus and Serial Adapters/Interfaces: graphics added Section Accessory Cables and Connectors for Host Interface added Description of Configuration of Boot Strap Options Switch (S1) revised. Tables with pin assignments for DPM and SDRAM Modes, Extension Bus Modes, MII Mode added. Description of boot strap options (S1) revised. 1 Device Description NXHX 51-ETM Development Board Hilscher Gesellschaft für Systemautomation mbh DOC120606HW05EN Revision 5 English Released PublicĢ Table of Contents 2/60 Table of Contents 1 INTRODUCTION About This Manual List of Revisions Conventions in this Manual Reference to Hardware Other Relevant Documentation DESCRIPTIONS AND DRAWINGS Description of the NXHX 51-ETM Drawings Block Diagram Printed Circuit Board Operating Elements Push Buttons Switches Host Interface Configuration Jumper (X10) Interfaces Host Interface (X3) Mini-B USB Connector (X2, 5-pin) microsd Card Reader (X4) Fieldbus Connector (X5-10-pin) Fieldbus Connector (X6-10-pin) Serial Connector (X7-10-pin) USB Connector HI TOP (X8) ETM Connector (X9) *RJ45 RT-Ethernet (X50) Power Supply +24 V (X100) LEDs USING EXTERNAL DEBUGGERS ACCESSORIES Devices for Host Interface I/O Device at Host Interface (NXHX-IO) SDRAM Device at Host Interface (NXHX-SDR) PHY and Serial Dual-Port Memory Device at Host Interface (NXHX-PHY) PHY and SDR Memory Device at Host Interface (NXHX-PHYSDR) Parallel Dual-Port Memory at Host Interface Using NXHX 6-RE or NXHX 52-RE as Extension Bus at Host Interface Accessory Cables and Connectors for Host Interface Fieldbus and Serial Adapters/Interfaces NXHX-DP NXHX-CO.38ģ Table of Contents 3/ NXHX-DN NXHX-RS NXHX-CC NXAC-Power NXAC-JTAG-ETM REFERENCE Schematics Bill of Materials NXHX 51-ETM NXHX-IO NXHX-SDR NXHX-PHY NXHX-PHYSDR TECHNICAL DATA NXHX 51-ETM APPENDIX Matrix Label List of Figures List of Tables Contacts.60Ĥ Introduction 4/60 1 Introduction 1.1 About This Manual This manual describes the NXHX51-ETM development board List of Revisions Index Date Chapter Revision All Created All Structure of document revised.